![]() ![]() The button at the bottom will change to “Create 3D LUT…”. You can create additional 3D LUTs from any existing profile selected under “Settings” by going to the “3D LUT” tab and disabling “Create 3D LUT after profiling”. The settings should already be correct for the chosen 3D LUT parameters, but you may want to choose a larger or different testchart (the default one only has 26 patches and is suitable for a quick check, which ideally should be followed up by a more thorough examination with a larger chart).Ĭreating additional 3D LUTs with different settings from existing measurements If you want, you can verify the 3D LUT you have just created by going to the “Verification” tab and clicking the “Measurement report” button.For the eeColor, you have to save the 3D LUT and then use the eeColor tools to upload the 3D LUT to the device. ![]() If you created a madVR 3D LUT, click “Install 3D LUT” to install and activate the 3D LUT. The self check error should not be higher than 0.5 DE average and 5 DE peak.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |